Rampage Paintball Marker

Rampage Paintball Marker

Paintball Marker shot run on problem?

I just bought a Piranha Gti Rampage and whenever I pull the trigger once it keeps shooting just plain c02 out not balls.

NO I AM NOT LOW ON AIR THIS HAPPENED WHEN I JUST GOT MY TANK FILLED!

ALL OF MY O-RINGS ARE FINE

and after checking all this out I don't know what's wrong?

Your sear is bad. As your sear wears, it rounds out to the point that it won't catch and hold your bolt in the open position. Thus, the bolt falls and fires another round. This will repeat until your gun is out of co2, or until the sear catches the bolt. Without an egrip slowing down this action, the bolt moves so fast that it can't pick up a paintball, thus no balls are fired. Sometimes it will chop and gum up the action terrible. Just replace your sear, or you could try filing off the sear so it has a good sharp edge again. But really, sears aren't that expensive, and pretty simple to install. I know you don't want to hear this, but I got to say it anyways; wouldn't have happened if you had bought a Tippmann. Don't be mad, I'm just kidding, kinda. Sorry, just had to say it. Hope you have better luck with your gun once you get it up and running.